Manufacturer notes: Brushless DC motors have no brushes to get worn out -- they represent a huge leap forward in technology. Brushless output gives significantly higher efficiency and performance, and have a lower susceptibility to mechanical wear than their brushed counterparts.
Brushless motors offer several other advantages, including;
- Higher torque to weight ratio
- Increased torque per watt of power input (increased efficiency)
- Increased reliability and lower maintenance requirements
- Reduced operational and mechanical noise
- Longer lifespan (no brush and commutator erosion)
- Elimination of ionizing sparks from the commutator (ESD)
- Near-elimination of electromagnetic interference (EMI)
This advanced brushless motor boasts some impressive features:
-7075 Aluminum case
- Full CNC construction
- Fully hand-wound stator, maximizing copper content
- High-quality magnets
- CNC shaft cover with EZO bearing
- High-quality speed controller
- Replaceable speed controller
- High-quality D-type pinion gear
- Replaceable parts
- 52K RPM at 11.1v
Important installation notes Professional installation required. A 1.27mm hex key driver is required for installing the pinion gear. A small amount of slip-fit (green 638 recommended) threadlocker should be used to prevent pinion slippage. Threadlocker should not enter the bearing area and should have time to cure before using the motor.
Do NOT use a pinion pull/press tool for installing the pinion gear. This will destroy the electronics inside, unless the motor is properly disassembled and desoldered. Proper fitting of the AEG pistol grip plate is required.
Please take care when fitting your AEG's motor connectors to the tabs on the motor. These are soldered directly to the PCB inside the motor and they are more fragile than those on a standard brushed motor. Care should be taken not to bend them outwards or hyper extend them as this may result in them breaking.
A helpful installation video is provided by Warhead and goes into further detail:
Important MOSFET settings We have spent a significant amount of time designing our motor to be compatible with as many third-party MOSFETs and electronic trigger units as possible. For optimal performance with our motor, we recommend using the following settings across all brands of ETU and mosfets alike.
Please refer to each section below when setting up your AEG with our motor. For more information or to check compatibility please send us an email on info@warheadindustries.com or direct message us on Facebook.com/warheadindustries. Settings explained in further detail here: https://www.warheadindustries.com/suggested-mosfet-settings
BATTERY PROTECTION / LOW
VOLTAGE DETECTION SET TO: OFF
CYCLE DETECTION SET TO: ON
PRE-COCKING SET TO: OFF
ACTIVE BRAKING SET TO: PWM INCREASING IN 20% INCREMENTS
